Drywall repair is a common task in many homes. Although it’s tough, it’s not indestructible. The ideal techniques, skills level, and tools will depend on the size of the hole to be repaired. The process is simple, and many people can do it on their own. However, the task becomes more complicated as the repair area becomes bigger.
You may not need all the tools used during drywall repairs. Therefore, before you shop for the tools, consider the amount of work that you will do. Some of the tools include a putty knife, drywall saw, drill, drywall screws, spackle, and trowel.
Here are the steps for repairing drywall:
Remove the Damaged Part
Use a level to measure a straight line across the top and bottom of the damaged area. Next, cut across the lines using a drywall knife and stop at studs past the damaged parts. Continue cutting until you have removed all the damaged sections. If the damaged spots are located on corner walls, make sure you preserve the drywall covering the corner stud.
Install the Framing for Attaching the Drywall
Most contractors usually use two ways to join different pieces of drywall together. One of the most common techniques involves bisecting an undamaged piece at the stud. In this method, the stud is exposed. Some of the drawbacks of this trick include being time-consuming, and your hands must be steady to achieve the desired results.
You can save time by joining the existing stud to the new one. Some of the reasons for the popularity of this method include the fact that cutting the existing drywall in a straight line is unnecessary and strengthening the new one.
Cut and Attach a New Drywall
Once you have joined the old and new studs, measure the damaged spots and cut a corresponding piece. Ensure you measure the right drywall length, bend, and pop it. Next, cut the remnants. Once you’re done, place the ends in the center of a stud to strengthen the bond and ensure you have a strong bond. Attach your new drywall to the studs using about 12 inches screws.
Mud and Tape
Mud is recommended for filling gaps between new and existing drywall if they exceed 1/8 inch. Before you apply the compound, ensure it has the consistency of creamy peanut butter. Use the mud to cover all gaps and screw dimples in your drywall.
Once you are done, apply mesh across drywall gaps. The mesh and substance create a tight seal between the existing holes and a blank canvas for paint works. Allow them to sit for about an hour and add another layer of the compound. Sand the wall smooth and get rid of any existing debris. Finally, prime and paint your new drywall.
What Causes Drywall Damage?
There are numerous possible reasons why your drywall could be damaged. One of the most common culprits is plumbing leaks. Drywall bulging is one of the signs of water-related drywall damage. Another possible cause of damages is poor installation.